Q1 User Guide- Introduction
- Overview
- Getting Started
- Using the Q1
- Pairing
- Noise Reduction and Voice Isolation
- Multiple Calls (Call Waiting)
- Charging the Q1
- Setting Up Speed Dials
- Transferring Audio from the Q1 to your Phone
- Sensitivity Level
- Using More Than One Phone At The Same Time (Multipoint)
- Using your Q1 with your Computer
- Troubleshooting
- Q1 Reference
Transferring Audio from the Q1 to your Phone
The Q1 allows you to switch back to your phone at any time, even while you are on a call.
To disconnect the Q1 from your phone, just click "Vol +" and "Vol -" together. If you are on a call when you click the buttons, then the audio will be transferred back to your phone where you can continue the call.
If you disconnect the Q1 while you are on a call, you can switch the audio back to the Q1 again during the call. Just click the "Vol +" and "Vol -" buttons together again.
 | Not all phones support reconnecting to a Bluetooth headset during a call. If clicking the buttons together does not work, then you will have to wait until the end of the call to reconnect to the Q1. |
If you were not on a call when you disconnected from the Q1, then you will not be able to reconnect by clicking "Vol +" and "Vol -" again. In this case you can use the "Am I Connected?" voice command to reconnect the Q1 to your phone.