Q1 User Guide- Introduction
- Overview
- Getting Started
- Using the Q1
- Pairing
- Noise Reduction and Voice Isolation
- Multiple Calls (Call Waiting)
- Charging the Q1
- Setting Up Speed Dials
- Transferring Audio from the Q1 to your Phone
- Sensitivity Level
- Using More Than One Phone At The Same Time (Multipoint)
- Using your Q1 with your Computer
- Troubleshooting
- Q1 Reference
Audio Streaming
If your phone or Bluetooth device supports the A2DP audio streaming profile, then you can play audio through the Q1. This means that you can hear turn-by-turn direction information from a GPS application on your phone that supports A2DP, and listen to podcasts, music and more through your Q1.
To listen to audio, simply press play on your A2DP device: the audio will automatically transfer to the Q1.
 | Please note that audio streaming with A2DP was added to the Q1 in firmware version
8.19. If you have an older version of the firmware installed on your Q1, then you will need
to update your Q1 to the latest firmware release in order to use A2DP streaming.
You can check what version of the firmware is installed on your Q1 by looking at the version
number shown in the Bluetooth pairing list on your phone.
To update your Q1, please go to register.blueantwireless.com to register your Q1. This will give you access to the downloads area where you can download, install, and run the BlueAnt Q1 Updater software. |
Parent topic: Using the Q1